Help and support for Deep Sea Modules. Welland Engineering uses Deep Sea Modules on all its sets as we belive they represent excellent quality.
Much help and additional information can be found on the DSE website. You can visit the DSE website is: http://www.deepseaplc.com/
Can anyone advise me if the above unit can be configured to start and stop automatically on a 24 volt DC system, ie, Battery Bank, Thanks.
Hi My Aggreko generator will only crank over once then drops out in cold conditions, sometimes it starts in warm conditions. It has a Deep sea...
I would like to know how can i connect severals generators connected by MSC LINK to computer? Do i need to connect the computer to all generators to...
Hello, I'm starting a project about paralleling generators using DSE 5100 loadshare module. I was reading the manual and i undrestood that i need...
WV250 Genset, DSE3110 control module, showing a signal (ECM signal; CAN ECU shut down) and Gen-set is shutting down every after 20 to 30 minutes. ...
Hi all! I m currently working on communication of DSE5510 with MODBUS poll software . But i m getting READ ERROR and some times TIMEOUT ERROR. I...
We have a 100Kva Perkins Genset wth Mecc alternator, controller DSE3110, manual start. Now we will build an auto start panel (AMF+ATS) locally to...
I am having problem with the 3110 modules. The close generator output is not responding even after I change the module and use another one. I am...
Need to register the opening & closing time of gensets circuit breaker to DSE5510 Event Record.. Pls.advive. Thanks
Hi , have a deepsea 5210 showing wrong current draw. when i remove the plug from the rear socket the wrong current is still shown on the display?...
What is a deep sea module? And how does deep sea module control my diesel denerator? Thanks Miguel
How do you update the firmware in the Deep Sea modules?
Hi, I have a strange problem. I have a generators and it runs fine spot on at 1500RPM. Its a electronically managed TAD941GE. When load is...
Do the Volvo engines use EMS 2 or EMS 2b?
Hi, I want to protect the controller against people dialing into it with a module pin. How do I set a module pin?
The following video shows the responce from a DSE 7000 series controller when the CANBUS link is not working and you attempt to start the set. If...
The Fault When the set is running at around 230V LN, the module appears to read just over 250V LN. The reason for the fault Deep Seas...
I think that my Deep Sea 3110 module on my genset may have developed a fault would it be possible to take at apart and effect repairs of any kind?
On DSE 3110, 7210, 7310, 7320, 7220 and the new 7510 when available it is possible to upgrade the firmware on the modules. You can do this with...
You can configure a DSE 7310 module for a scheduled startup quite easily using the pc setup software. Simply select the scheduler option from the...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
