Genset turning off automatically within 1-2 minutes after start

[nexuspower]

At the time of overhauling of 1300 series (HEUI injector) engine, the injector pressure control sensor (which is installed into the cylinder head) has been broken. We didn’t replace the sensor, because its not available here.
Now we are facing problem to run the Genset, after start the Genset, it’s going off automatically after1-2 minutes.
Do you have any solution? Please advice

[wellandpower]

I think you must be able to replicate this sensor using simple electronics.

If you use the engine manuals it probably tells you the sensor range.

However I. All cases, they are there for a reasons dn you don't want to damage the engine in this way, so I would just order a new one.